Electric Heating

• FFC Range
• for piping
• Tubelar element in annealed copper tube of ø 6,4 mm, insulated with electro-melted and lamination-compressed magnesium oxide
  
• Power: 125 W/m
• Non heating zone: 110 mm
• Finished with silicone hood and cable on both sides, length: 300 mm
• Voltage: 230 Vac

• CSK 060 Range
• with PTC heating element and thermostat
• Heating element: self-regulating ptc heating element
• Supply current: 150 - 250V ac/dc. Max 265V
• Housing: <80 °C (According to VDE 0100), except over top grille
• Connection: 2 poles, 2.5 mm² terminal
• Fixing: clip for 35mm DIN rail, EN 60715
• Mounting: position vertical
• Storage: temp. -45 °C (-49 °F) - 70 °C (158 °F)

The stainless steel tube and polyester screw cap NA electrical resistors range comes with brass coupling plug is used to heat all kinds of water, of whatever source and treatment.

• Standard voltage: 150 - 250 Vac/dc. Max 265 V
• Heating element: PTC. Self regulating heating element
• Radiator: Anodized aluminium
• Electrical class: II. Test voltage 4000 V
• Degree protection: against moisture IP54
• Connection: Silicone cable 2x0'75 mm². Length 300 mm
• Mounting: Clip for 35 mm DIN rail, EN 50022
• Fitting position: preferably vertical
• Storage temp: -45 °C (-49 °F) - 70 °C (158 °F)

Comes with brass coupling plug

• FZK 011 Series
• Temperature range: 5 ... 60 °C adjustable
• Temperature differential: 4 °C ± 1 °C
• Sensor: Bimetallic
• Supply current: 230 - 250 Vac. 50 - 60 Hz
• Contact class: Commuted contacts
• Connection: Flanges on the housing, 4 x 2'5 mm²

The stainless steel tube and polyester screw cap T electrical resistors range comes with brass coupling plug is used to heat all kinds of water, of whatever source and treatment.

• Models PQC
• Dimensions: 62,5 x 62,5 mm
  
• Iron-Chrome aluminium resistance wire
• Parallel translucent quartz tubes
• Highly reflective aluminised steel body that ensures low loss of radiation from back of the heater
• Supplied with two M5 x 30 screws which extend from the rear of the heater
• Supplied with two 100 mm ±10 mm ceramic beaded power leads
• Element dimensions and design can be adjusted to suit customer heating requirements
• Quartz elements can also be supplied with an in-built type K thermocouple
• Standard voltage ~230 V

• Model EFR01246
• 65% RH
• Hysteresis (Humidity): 5% RH (±1 RH tolerance) at 25 °C
• Reaction time: Approx. 5 sec.
• Contact class: Inverter contact
• Connection capacity:
  240 Vac,8 (1.6) A
  120 Vac.8 (1.6) A
  24 V dc, 4 A
• Connection: 5 pole flanges, even max 0.5 Nm